About 68 results
Open links in new tab
  1. THHN vs. THWN-2 | Information by Electrical Professionals for ...

    Aug 14, 2024 · SIMpull THHN® Copper Wire 600 Volts. Copper Conductor. Thermoplastic Insulation/Nylon Sheath, Heat, Moisture, Gasoline and Oil Resistant II. All sizes rated both THHN …

  2. THHN Wire Without Conduit as Ground between Main and Subpanel

    Jan 14, 2025 · It would be easy to run a 10-AWG THHN wire along and through the overhead floor joists, but much more difficult to run conduit. Does NEC allow the use of a 10-AWG THHN wire to be …

  3. THHN / THWN wire temperature rating | Information by Electrical ...

    Nov 15, 2018 · THHN is rated for 90 degree C and THWN is rated for 75 degree C but both of these ratings can be listed on the same wire. Just want to make sure I have this right, if installed indoors …

  4. THHN inside conduit - what to use inside wall cavity

    Aug 2, 2024 · The plain THHN had a higher temperature rating, significant when the conductors carry close to their rated amperage or the conduit or a drilled hole is stuffed with wires close to the limit. …

  5. THHN #6 stranded for GEC to ground rods... | Information by Electrical ...

    Jun 27, 2021 · Given the price of copper, what are thoughts about using THHN (in the appropriate size) for the GEC? I need to update a 100-amp service in a small building. I have various scrap chunks of …

  6. Is it permissible to use THHN/THWN cable instead of USE-2 cable in ...

    Dec 6, 2023 · Welcome to the forum. THHN/THWN is a single conductor, not a cable. Yes, it can be used outdoors and underground as long as it is completely enclosed in a complete conduit assembly.

  7. THHN/THWN-2 Question | Information by Electrical Professionals for ...

    Apr 20, 2021 · THHN/THWN without the "-2" rating is what #10 and smaller could be, which means wet locations are limited to 75C ampacity as the starting point for your adjustment/temperature …

  8. Minimun bending radius 600MCM THHN 480V | Information by …

    May 25, 2018 · The only NEC reference I've found for "Conductor Bending Radius" is only for 1000V (600V in earlier versions) or greater. (Part II. Requirements for over 1000 Volts, Nominal - 300.34 …

  9. THHN used in wet locations | Information by Electrical Professionals ...

    Jan 10, 2024 · I see NEC table 310.4 A list THHN for DAMP or dry locations but not for wet locations However home depot product description list their THHN for wet locations. I thought wet listed wire …

  10. #8 THHN for NEMA 14-50 EV charging receptacle

    Jun 24, 2024 · The issue was not mine but a good friend and colleague I had a discussion with that said you cannot use #8 THHN for a 14-50 . We here agree. We agree that you cannot use #8 then with a …